TM 5-6675-324-14
MOS: 35E, Special Electronic Devices Repairer
TOOLS: 3/16 in. Flat Tip Screwdriver
1/8 in. Flat Tip Screwdriver
No. 2 Cross Tip Screwdriver
No. 2 Jeweler's Screwdriver
5/64 in. Hex Head Key Wrench
Encoder Calibrator
SUPPLIES: Spar Varnish (Item 26, Appendix E)
Technical Acetone (Item 1, Appendix E)
Dip-Clip (14 pin)
a. Remove planimeter encoder from housing (paragraph 5-20.1).
b. With technical acetone, remove resin covering from adjustment
potentiometers, P1 and P2.
c.
Remove four screws and washers from top of auto-scaler. Lift off top.
d. Plug encoder into El encoder socket on back of auto-scaler.
e.
Set encoder switch to El.
CAUTION
Plug transformer power cable into auto-scaler before connecting it to
wall outlet. Failure to do so could result in damage to auto-scaler.
f. Plug transformer power cable into POWER supply jack on back panel of
auto-scaler.
Plug transformer power cable into wall outlet.
g.
5-145
