TM 5-6675-324-14
(4) Use printout to verify program, and load magnetic card.
k. Recording program on magnetic card.
(2) Obtain printout to verify program.
(a) Press
key.
(b) Press
and PRINT:PRGm key.
NOTE
If printout does not verify program, repeat steps (1) and (2).
(3) Set PRGM/RUN switch to PRGM.
If display does not show OOO or OOl, press
key.
(4) Select unclipped and unmarked magnetic card from packet of cards.
CAUTION
l Hold magnetic card by the edge. Be sure hands are clean. Grease, oil,
and other materials can damage magnetic card.
l Do not continue to hold card after it is grasped by feed mechanism. Damage
to magnetic card may occur.
(5) Load side one of magnetic card through reader. If display ind i c a t e s
ERROR, press any key to clear.
(6) Pass side one through reader again. If calculator displays Crd, re v e r s e
card and load side two.
(7) Print out program to verify.
(8) Mark magnetic card to identify program.
(9) To protect contents of magnetic card from being erased, cut corners of
card along notches.
5-49