TM 5-6675-324-14
(2) Activate QPS:
(a) Plug foot switch into CLEAR input jack on back panel of auto-scaler.
(b) Plug remote tracer switch into ACCU input jack on back panel of
auto-scaler.
(c) Plug linear measuring probe into El, encoder socket on back panel of
auto-scaler.
(d) Plug power transformer cable into POWER supply jack on back panel of
auto-scaler.
(f) Plug power cord into back of calculator.
(g) Plug power cord into wall outlet.
(h) Set encoder OFF/E2/E1 switch on back panel of auto-scaler to El.
(i) Set AUDIO/OFF switch on back panel of auto-scaler to AUDIO.
(j) Set auto-scaler B/ACCU/A/OFF switch to A.
(k) Set auto-scaler MAN/AUTO switch to AUTO.
(1) Set auto-scaler X MEMORY switch to 1.
(m) Set calculator OFF/ON switch to ON.
(n) Set calculator NAN/TRACE/NORM switch to NORM.
(o) Set calculator PRGM/RUN switch to RUN.
(p) Press following keys:
(3) Tape piece of paper to table.
(4) Draw line exactly 10 inches long.
(5) Label ends of line A and B.
.
NOTE
Foot switch must remain depressed until ready to begin measurement, so
that movement and handling of linear measuring probe will not increment
counter.
(6) Press CLEAR button on auto-scaler.
(7) Depress foot switch to initiate ACCU and freeze count at zero.
5-53