TM 5-6675-323-14
(p)
Press
following
keys:
CAUTION
Grease, oil, or
H o l d magnetic cards by edge. Be sure hands a r e c l e a n .
o t h e r materials may damage magnetic cards.
( 3 ) Load preprogrammed magnetic card (paragraph 9-6. 2h), Program I, into
calculator.
(4) Tape drawing or map to be measured and paper for layout to table.
( 5 ) I f n e e d e d , a l i n e l i n e a r m e a s u r i n g p r o b e ( p a r a g r a p h 9 - 6 . 2 n ) . R e c o r d RL
value.
NOTE
provided with equipment. Alinement is performed as a check.
(6) Key in scale of map or drawing on which measurements will be made.
NOTE
I f l a y o u t i s t o be drawn to a different scale than original map or
drawing, key in scale for layout.
(7)
Press
and a .
(8)
Press
a n d d for printout in feet and inches.
(9) Press CLEAR button to clear auto-scaler.
D o n o t r e l e a s e u n t i l r e a d y t o b e g i n measurement.
(10) Press foot switch.
(11) Position linear measuring probe so that pricking pin is at beginning of
length to be measured.
(12) Release foot switch.
(13) Make measurement by tracing length of line with linear measuring probe.
(14) Depress, then release foot switch to initiate print command.
(15) Position linear measuring probe on layout sheet at beginning of line just
measured.
(16)
Press
pricking
pin.
9-66
