TM 5-6675-323-14
NOTE
Calculator will print horizontal and true slope surface area of shape
last measured, followed by totals (added or subtracted) of horizontal
and true slope surface areas.
(6) Keeping foot switch depressed, reposition planimeter near shape to be
measured.
( 7 ) Make next measurement.
(8) If change is made in planimeter function or if new scales or slope ratios
B e g i n measurement procedures.
are used, press q to initiate measurement.
Measuring areas without the calculator.
s.
( 1 ) Assemble QPS with planimeter.
(2) Activate QPS:
(a)
P l u g foot switch into ACCU input jack on back panel of auto-scaler.
P l u g p l a n i m e t e r into E2 e n c o d e r s o c k e t o n b a c k p a n e l o f a u t o - s c a l e r .
(b)
P l u g power transformer cable into POWER supply jack on back panel of
(c)
auto-scaler.
P l u g power transformer cable into wall outlet.
(d)
P l u g power cord into back of calculator.
(e)
P l u g power cord into wall outlet.
(f)
O F F / E2 / E1 s w i t c h o n b a c k o f a u t o - s c a l e r t o E2 .
Set encoder
(g)
S e t A U D I O / O F F switch on back panel of auto-scaler to AUDIO.
(h)
S e t a u t o - s c a l e r B/ACCU/A/OFF switch to A.
(i)
S e t auto-scaler MAN/AUTO switch to MAN.
(j)
S e t a u t o - s c a l e r X MEMORY switch to 1.
(k)
S e t c a l c u l a t o r OFF/ON switch to OFF.
(l)
( 3 ) Tape map o r d r a w i n g t o b e m e a s u r e d t o t a b l e .
(4) Select correct tracer arm length.
(5)
If
needed,
aline
planimeter
for
tracer
arm
length
selected
(paragraph
R e c o r d RT v a l u e .
9-6.21).
9-61
