TM 5-6675-323-14
CAUTION
Hold magnetic cards by edge. Be sure hands are clean. Grease, oil, or
o t h e r materials may damage magnetic cards.
(3) Load preprogrammed card (paragraph 9 - 6 . 2 h ) , P r o g r a m I , i n t o c a l c u l a t o r .
( 4 ) Tape drawing or map to remeasured t o t a b l e .
(5) When multiplying counts by one constant, key in constant, press
and
.
(6) Press CLEAR button to clear auto-scaler.
(7) Using point counter pen, make point count.
(8) Press PRINT to obtain results of count.
(9) To make point count with two to four constants, follow steps (1) through
(4).
(10) When multiplying counts by two to four constants, key in each constant
followed
by
.
(11)
After
last
constant
has
been
keyed
in,
press
,
,
and
e.
(12) Press CLEAR button to clear auto-scaler.
(13) Using point counter pen, make point count.
(14) Press PRINT to obtain results of count.
(15) Change X MEMORY switch to 2.
(16) Press CLEAR button to clear auto-scaler.
(17) Using point counter pen, make point count.
(18) Press PRINT to obtain results of count.
(19) Repeat steps (13) through (18) if there is another constant being used.
x.
Standard volume run using contour method.
( 1 ) Assemble QPS with planimeter.
(2) Activate QPS.
(a) Plug foot switch into ACCU input jack on back panel of auto-scaler.
( b ) P l u g l i n e a r m e a s u r i n g p r o b e i n t o E1 e n c o d e r S o c k e t o n b a c k p a n e l o f
auto-scaler.
9-70
