TM 5-6675-323-14
(c) PIug power transformer cable into POWER supply jack on back panel of
auto-scaler.
(d) Plug power transformer cable into wall outlet.
(e) Plug transformer power cord into back of calculator.
(f) Plug power cord into wall outlet.
( 9 ) S e t e n c o d e r O F F / E2 / E1 s w i t c h o n b a c k p a n e l o f a u t o - s c a l e r t o E2 .
(h) Set AUDIO/OFF switch on back panel of auto-scaler to AUDIO.
(i)
Set
a u t o - s c a l e r B / A C C U / A / O F F switch to A.
a u t o - s c a l e r MAN/AUTO switch to MAN.
(j)
Set
( k ) S e t a u t o - s c a l e r X MEMORY switch to 1.
(l)
Set
c a l c u l a t o r OFF/ON switch to ON.
( m ) S e t c a l c u l a t o r MAN/TRACE/NORM switch to NORM.
(n)
Set
c a l c u l a t o r PRGM/RUN switch to RUN.
(o)
Press
following
keys:
,
,
,
and
.
CAUTION
Hold magnetic cards by edge. Be sure hands are clean. Grease, oil, or
o t h e r materials may damage magnetic cards.
( 3 ) Load preprogrammed magnetic card (paragraph 9-6.2h), Program II, in
calculator.
(4) Tape map or drawing to remeasured to table.
(5) Select correct tracer arm length.
NOTE
The tracer arm length should be shortest one possible that will allow
entire shape to be measured without moving the planimeter.
(6) If needed, aline planimeter with tracer arm length selected (paragraph
9-6.21).
( 7 ) R e c o r d RT v a l u e .
9-71
