TM 5-6675-323-14
d. Carefully note parts' relationship and disassemble brush holder.
Desolder electrical connections to brush.
e.
f. Solder new brush to electrical connections.
R e a s s e m b l e brush holder.
g.
h. Aline brush holder hole with mounting hole and secure with screw.
Reinstall cable clamp and flat washer and secure with screw.
i.
P l u g in power cord and turn power on.
j.
6-16.5 Remove/Install Split-Stage Light Table.
MOS: 41B, Topographic Instrument Repair Specialist
PERSONNEL: Two persons are required to perform this procedure.
T O O L S : Socket Wrench Set (1/2 in. Drive)
Split-Stage Light Table
SUPPLIES:
T u r n power off and unplug power cord.
a.
b. Coil and tape power cable.
6-50
