TM 5-6675-323-14
(3) Thread cleated cable end down through space normally occupied by
pulley 4 and anchor cleated end in bracket.
CAUTION
P u l l e y will not rotate if washer is not in place.
(4) Reinstall pulley 4 making sure that washer is reinstalled under
pulley, and thread cable around pulley.
(5) Bypass pulley 3 and thread cable around pulley 2 to pulley 1.
(6) Thread cable end adjustment block up into bracket above pulley 1
and install adjust nut finger tight only.
(7) Check that cable is around pulleys 1 and 2. Then complete stringing
by threading cable around pulley 3.
(8) Adjust tension nut until 5/16 in. (8 mm) of thread is exposed above
nut.
h.
Position pen carriage arm at pen stable end of plotter. Adjust cable
t e n s i o n f o r 3 2 5 2 5 g . R e f e r to cable tension adjustment procedure
i.
Manually exercise pen carriage arm several times along X-axis and
recheck cable tension. Readjust if necessary. Repeat manual exer-
cising and checking after each adjustment until tension is set to
325 25 g.
Lower upper deck assembly and reinstall rear hood.
j.
3-298
