TM 5-6675-323-14
(7) From pulley 2, thread crimped cable end through feed through hole
and up behind upper right bracket to anchor crimped end. Cut off
excess cable end.
(8) Thread longer cable length around pulleys 3, 4, and 5.
(9) Anchor crimped cable end in lower left bracket.
(10) Remove tape from motor windings.
(11) Remove two thumbscrews holding plotter arm in place.
(12) Move pen carriage arm assembly to extreme right edge of platen.
(13) Move pen holder at the assembly to the top of the arm assembly.
3-293
