TM 5-6675-320-14
(c) Position paper squarely against ridge at bottom of platen and
against paper stop on left side. Smooth paper with back of hand.
(d) Press CHART HOLD switch.
(CHART LOAD lamp should go off.)
( 7 ) L o a d p e n s:
WARNING
T o a v o i d p o s s i b l e i n j u r y t o f i n g e r s , a l w a y s t u r n p l o t t e r o f f w h e n d i r e c t l y
storing pens.
(a) Turn LINE power switch to off (0).
(b) Remove cap from first pen.
( c ) P l a c e t i p o f p e n i n b o o t a t b a s e o f s t a l l.
(d) Gently press pen down and in until it snaps in place.
( e ) R e p e a t f o r a l l p e n s.
(8) Connect HP-IB Interface bus to rear of plotter. Controller ROM should
be plugged into computer (HP9825A only).
Turn LINE power switch to on (I).
(9) Perform dynamic test:
lbd3, and
SHIFT, A,
( a ) I n s e r t 9 8 0 0 s e r i e s t e s t c a r t r i d g e i n t o c o m p u t e r .
(b) Load test cartridge by pressing STOP, ERASE a, EXECUTE, RESET,
EXECUTE.
(c) When computer displays ENTER MODEL # TO BE TESTED, press 9872,
and CONTINUE.
4-165
