TM 5-6675-320-14
(12) Enter sample print program in computer.
(a) Press ERASE A.
(b) Press lbl “I AM A 9872 PLOTTER”.
(c) Press STORE, LIST, and EXECUTE. Check printout of program.
(d) Press RUN.
(e) Check to see plotter draws “I AM A 9872 PLOTTER.”
d . H P - I B o p e r a t i o n a l t e s t .
WARNING
Death or serious injury may occur from electrical shock. Plotter is equipped
with
a
three-conductor
power
cable
which
grounds
plotter.
Do
not
operate
plotter from an ac outlet that does not have connected ground pin.
CAUTION
Be sure power is off before plugging ROM’s or
equipment.
Damage to equipment will result.
HP-IB Interface cable into
(1) Check that computer power is off.
Plug HP-IB cable into I/O slot in
back of computer.
(2) Plug ROM into slot in front of computer.
(3) Turn on computer.
Verify lazy "T" is on computer.
NOTE
If lazy “T” does not appear, remove HP-IB Interface and press RESET. If it
still does not appear, refer to direct/general support maintenance.
(4) Enter program line shown below.
(5) Press EXECUTE and verify that display shown above appears.
4-167
