TM 5-6675-320-14
( 1)
( 2 )
(3)
(4)
(5)
( 6)
( 7)
( 8)
( 9)
(10)
Remove power from the plotter.
Remove all interface cables.
Open the plotter.
Apply power to the plotter.
Set the SELF TEST switch S4-2 to the on position.
Press the RESET switch S5 pushbutton (red).
The self-test LEDs will flash sequentially as a lamp test.
Press the CONTINUE switch S3 pushbutton (green).
The test will run to the end of the automatic tests or to a fault
i n d i c a t i o n.
To continue after any error, press the CONTINUE push-
button S3 (green).
The self-test LEDs will flash in unison when the automatic tests ar e
complete or indicate the binary number of the failed step if one is
found.
4-169
