TM 5-6675-320-14
Table 4-10. PLOTTER PROGRAMMING LANGUAGE - Cont
Statement Identification and Use
Program
Statement
Statement Syntax, Explanation, and Input Instructions
dig - C o n t
Coordinate values are assigned to variables specified by digi-
t i z e s t a t e m e n t i n f o l l o w i n g o r d e r:
NOTE
S e l e c t c o d e f o r p l o t t e r i s s et
X-Coordinate Value
Y-Coordinate Value
Pen Status
(0 = Up, 1 = Down)
To cancel diqitize statement without
at factory to 705.
Variable 1
Variable 2
Parameter
( I f S p e c i f i e d )
entering values, press
wrt
STOP key.
If digitize statement is executed-from program,
STOP key will also stop program at end of line containing
d i g i t i z e s t a t e m e n t .
S p e c i a l d i g i t i z i n g s i g h t i s p r o v i d e d w i t h p l o t t e r w h i c h a l l o w s
y o u t o v i s u a l l y p o s i t i o n p e n d i r e c t l y o v e r p o i n t t o b e d i g i-
t i z e d .
Sight is loaded and stored like pen .
NOTE
If more than one point is to be digitized, then pro-
gram must contain looping statements to return to and
repeat program step containing digitize command or con-
t a i n s e v e r a l d i g i t i z e c o m m a n d s . P l o t t e r c a n o n l y d i g i-
tize one point each time digitize command is encountered.
WRITE.
I d e n t i f i e s a d d i t i o n a l p l o t t e r c o n t r o l c o m m a n d s.
Syntax:
wrt 705,
“Command Code”
NOTE
S e l e c t c o d e f o r p l o t t e r , s e t a t f a c t o r y , i s 7 0 5 .
4-95
