TM 5-6675-320-14
Table 410. PLOTTER PROGRAMMING LANGUAGE - Cont
Statement Identification and Use
Program
Statement
Statement Syntax, Explanation, and Input Instructions
wrt - Cont
S e n d i n g " S LN or ‘ S L O ” to plotter defaults character slant to
v e r t i c a l o r 0°
wrt 705,
“CS ( 0 - 4 )”
Character sets command designates one of five sets (O-4) as
standard character set.
This character set will be used for
a l l l a b e l i n g a n d l e t t e r i n g o p e r a t i o n s.
Character Set O is
a u t o m a t i c a l l y s e t w h e n e v e r p l o t t e r i s i n i t i a l i z e d.
NOTE
P l o t t e r , w h e n i n i t i a l i z e d , a u t o m a t i c a l l y s p e c i-
fies ANSI-ASCII character set (set 0) as both
“standard” and “alternate” sets.
The p c lr
statement, however, designates 9825 character
set (set 1) as standard set and set 0 as alter-
nate set.
Following keys are used to switch from
standard character set to alternate set and back:
Select Standard Set = SHIFT F2
Select Alternate Set = SHIFT F3
4-100
