TM5-6675-319-14
m.
Reinstall bottom bearing on shaft and tighten with setscrews.
n.
Reinstall bottom bearing and shaft in fan housing and secure with bolts,
washers, and nuts.
o.
Reinstall fan and fan cover.
p.
Reinstall top bearing on shaft and tighten with setscrews.
NOTE
Do not tighten mounting bolts and nuts.
S l a c k i s r e q u i r e d t o r e i n s t a ll
c e n t r i f u g a l f a n b e l t.
q .
Secure top bearing and shaft to welded cross bar and verify that fan
s p i n s f r e e l y.
CAUTION
Be careful not to damage tubing or wiring during reinstallation of
centrifugal fan/motor assembly.
r .
Reinstall centrifugal fan/motor assembly into processor and secure with
mounting bolts.
s .
Reinstall pulley on shaft and tighten with setscrew.
t .
Reinstall belt on pulleys and adjust (paragraph 2-16.2).
2-20.
6
Remove/Install Recycling and Storaqe Tank.
MOS:
83FJ6, Reproduction Equipment Repairer
PERSONNEL:
Four persons are required to perform this procedure.
TOOLS :
12 in. Adjustable Wrench
1 1/16 in. Combination Wrench
14 in. Pipe Wrench
1/2 in. Drive Socket Set
1 / 4 i n . D r i l l
1 / 4 i n . D r i l l B i t
Pop Rivet Gun
SUPPLIES:
Thread Sealant (Item 37, Appendix E)
Storage Tank
Recycling Tank
1/4 in. Pop Rivets
Silicone Sealant (Item 29, Appendix E)
2-144
