TM 5-6675-318-14
Section V
DIRECT/GENERAL SUPPORT MAINTENANCE
5-18.
REPAIR PARTS, SPECIAL TOOLS; TEST, MEASUREMENT, AND DIAGNOSTIC EQUIPMENT
(TMDE); AND SUPPORT EQUIPMENT.
5-18.1 Common Tools and Equipment.
For authorized common tools and equipment,
refer to the Modified Table of Organization and Equipment (MTOE) applicable to your
u n i t .
5-18.2 Special Tools; Test. Measurement, and Dignostic Equipment; and Support
Equipment.
Special Tools, TMDE, and Support Equipment is listed in the applicable
repair parts and special tools list and in Appendix B of this manual.
5 - 1 8 . 3 R e p a i r P a r t s . R e p a i r p a r t s a r e l i s t e d a n d i l l u s t r a t e d i n t h e R e p a i r P a r ts
and Special Tools List, TM 5-6675-318-24P covering direct/general support mainte-
nance for this equipment.
5-19. DIRECT/GENERAL SUPPORT TROUBLESHOOTING PROCEDURES.
a. Direct/general support troubleshooting procedures cover the most common
malfunctions that may be repaired at the direct/general support level. Repair or
adjustment requiring specialized equipment is not authorized unless such equipment
i s a v a i l a b l e .
Troubleshooting procedures used by lower level maintenance should be
conducted in addition to the direct/general support troubleshooting procedures.
b . T h i s m a n u a l c a n n o t l i s t a l l t h e p o s s i b l e m a l f u n c t i o n s o r e v e r y p o s s i b l e t e s t /
inspection and corrective action.
I f a m a l f u n c t i o n i s n o t l i s t e d o r i s n ot
c o r r e c t e d b y a l i s t e d c o r r e c t i v e a c t i o n , n o t i f y y o u r s u p e r v i s o r.
c .
For unidentified malfunctions, use the following schematic or the foldout
located at the end of this manual for further fault analysis.
5-12
