TM 5-6675-318-14
procedures assigned for this equipment.
assigned for this equipment.
3-26. PREPARATION FOR STORAGE OR SHIPMENT. C o n t a c t y o u r b a t t a l i o n f o r p a c k i n g a n d
shipping instructions.
Section X DIRECT/GENERAL SUPPORT MAINTENANCE
3-27. REPAIR PARTS, SPECIAL TOOLS; TEST, MEASUREMENT, AND DIAGNOSTIC EQUIPMENT
(TMDE) ; AND SUPPORT EQUIPMENT.
3 - 2 7 . 1 C o m m o n T o o l s a n d E q u i p m e n t . F o r authorized common tools and equipment,
r e f e r to the Modified Table of Organization and Equipment (MTOE) applicable to your
unit.
3 - 2 7 . 2 Special Tools; Test, Measurement, and Diagnostic Equipment; and Support
E q u i p m e n t . Special Tools, and TMDE, and Support Equipment is listed in the applicable
repair parts and special tools list and in Appendix B of this manual.
3-27.3 Repair Parts. Repair parts listed and illustrated in the Repair
Parts
and Special Tools List, TM 5-6675-318-24P covering direct/general support
m a i n t e n a n c e for this equipment.
a. Direct/general support troubleshooting procedures cover the most common
malfunctions that may be repaired at the direct/general support level. Repair or
adjustment requiring specialized equipment is not authorized unless such equipment
i s a v a i l a b l e . Troubleshooting procedures used by lower level maintenance should be
conducted in addition to the direct/general support troubleshooting procedures.
b. If the graphics plotter does not power up when turned on, verify that 120 V
If voltage is not present, plug equipment into
ac is present at the receptacle.
receptacle with power available and proceed with equipment troubleshooting. Perform
no-power procedures for dead receptacle (Table 1-4).
NOTE
Sufficient data is not available for you to test or troubleshoot printed
c i r c u i t b o a r d s . W h e n a s s o c i a t e d w i r i n g , ribbon cables, power cords and
o t h e r r e l a t e d e l e c t r i c a l c o m p o n e n t s h a v e b e e n eliminated as possible
faults, then the printed circuit boards must be substituted, one for one,
until the fault is isolated.
