TM 5-6675-318-14
d.
HP-IB
operational
test.
WARNING
Death or serious injury may occur from electrical shock. Plotter is
equipped with three-conductor power cable which grounds plotter. Do not
operate plotter from ac outlet that does not have connected ground pin.
CAUTION
B e sure power is off before plugging HP-IB ROMs or HP-IB Interface cable
i n t o equipment or damage to equipment will result.
in
back
of
( 1 ) Turn off computer power. Plug HP-IB card into I/0 slot
computer.
(2) Plug plotter extended and general I/O ROM into slot n f r o n t o f
computer.
(3) Turn on computer. Verify lazy tee "
" display is on computer.
NOTE
I f lazy tee does not appear, remove HP-IB Interface and press RESET. If
it still does not appear, troubleshoot computer.
(4) Enter program line shown below.
rds (7,A,B,C) D; dst A,B,C,D
PROGRAM LINE:
76.00
64.00
0.00
213.00
DISPLAY
(5) Press EXECUTE and verify that display shown above appears.
(6) If display does not return after line is executed, press RESET and
rotate HP-IB Interface select code switch to O, then back to 7, carefully with a
screwdriver.
(7) Repeat step (4).
(8) If display does not return or display is incorrect, card is defective.
3-65
