TM 5-6675-318-14
PREPARATION FOR STORAGE OR SHIPMENT.
a.
S e c t i o n may be stored or shipped either mounted on trailer chassis or
Preparation of trailer chassis is covered in TM 5-2330-305-14 and should
unmounted.
be referred to when trailer-mounted section is prepared for storage and shipment.
TM 5-4120-367-14 must be reviewed for instructions covering air conditioner/heater.
b.
Remove consumable supplies that have limited shelf life or broken seals. Re-
place missing items and be sure that all remaining consumable supplies are at
Be sure all major components are operational.
authorized levels.
c.
Remove all unauthorized or personal equipment from section.
d. Move all classified material or sensitive data to proper storage. Complete
all accountability and/or transfer of documents.
e.
R e f e r to Preparation for Movement (paragraph 1-6.2) and follow applicable
steps and any additional steps directed by proper authority.
Section V DIRECT/GENERAL SUPPORT MAINTENANCE
(TMDE); AND SUPPORT-EQUIPMENT. - -
1-18.1 Common Tools and Equipment. For a u t h o r i z e d common tools and equipment,
r e f e r t o t h e M o d i f i e d T a b l e o f O r g a n i z a t i o n and Equipment (MTOE) applicable to your
unit.
1 - 1 8 . 2 Special Tools; Test, Measurement, and Diagnostic Equipment; and Support
Equipment.
S p e c i a l Tools, TMDE, and Support Equipment is listed in the applicable
repair parts and special tools list and in Appendix B of this manual.
1-18.3 Repair Parts. Repair parts are listed and illustrated in the Repair Parts
and Special Tools List, TM 5-6675-318-24P covering direct/general support
m a i n t e n a n c e for this equipment.
1-18.4 Electrical System. Direct/general support level of maintenance for the
repair of the section's electrical system will consist of electrical wiring repair
using standard electrical wiring repair procedures.
DIRECT/GENERAL SUPPORT TROUBLESHOOTING PROCEDURES.
a. Direct/general support troubleshooting procedures cover the most common
malfunctions that may be repaired at the direct/general support level.
R e p a i r or
adjustment requiring specialized equipment is not authorized unless such equipment
i s a v a i l a b l e . Troubleshooting procedures used by lower level maintenance should be
conducted in addition to the direct/general support troubleshooting procedures.
b. This manual cannot list all the possible malfunctions or every possible
test/inspection and corrective action.
If a malfunction is not listed or is not
corrected by a listed corrective action, notify your supervisor.
c. For unidentified malfunctions, use the facing schematic or the foldout
located at the end of this manual for further fault analysis.
