TM 5-6675-317-14
b.
Remove screws and washers holding stainless steel tank and casing
to chassis.
c.
Lift stainless steel tank and casing free. Set aside.
NOTE
Do not disconnect wires to transducer.
d.
Tag and disconnect power
e.
Press sides of defective
f.
Install new power switch
into hole.
cord wires from power switch.
power switch and remove from chassis.
in chassis.
Push power switch until tabs lock
g.
Reconnect power cord wires to power switch. Remove tag.
h.
Reinstall stainless steel tank and casing. Secure with screws and
washers.
i.
Fill stainless steel tank 1/3 full with water.
j.
Plug in power cord and turn power on. Check that water surface
agitates.
5-13
