TM 5-6675-317-14
f.
Disconnect capacitor wires from circuit board.
g.
Tag and disconnect two transducer wires from circuit board.
h.
Remove defective circuit board.
i.
Install new circuit board.
j.
Reconnect two transducer wires to circuit board.
k.
Reconnect capacitor wire to circuit board.
l.
Reconnect power switch wire and power cord wire
m.
Reinstall three screws, one nut, and one washer
chassis.
to circuit board.
holding circuit board to
n.
Reinstall stainless steel tank and casing. Secure with screws and
washers.
o.
Fill stainless steel tank 1/3 full with water.
p.
Plug in power cord and turn power on. Check that water surface
agitates.
5-17. PREPARATION FOR STORAGE OR SHIPMENT. Contact your battalion for packing
and shipping instructions.
Section V DIRECT/GENERAL SUPPORT MAINTENANCE
There are no direct/general support maintenance procedures assigned for this
equipment.
5-15
