TM 5-6675-317-14
Section III
5-8. LUBRICATION INSTRUCTIONS.
OPERATOR MAINTENANCE
This equipment does not require lubrication.
5-9. TROUBLESHOOTING
procedures assigned for
PROCEDURES. There are no operator troubleshooting
this equipment.
5-10. MAINTENANCE PROCEDURES. operator maintenance is limited to performance of
regular preventive maintenance checks and services and replenishment of cleaning
solution.
5-11.
5-12.
MENT
5-12.1
Section IV ORGANIZATIONAL MAINTENANCE
LUBRICATION INSTRUCTIONS. This equipment does not require lubrication.
REPAIR PARTS, SPECIAL TOOLS; TEST, MEASUREMENT, AND DIAGNOSTIC EQUIP-
(TMDE); AND SUPPORT EQUIPMENT
Common Tools and Equipment.
For authorized common tools and equipment,
refer to the Modified Table of Organization and Equipment (MTOE) applicable to your
unit.
5-12.2 Special Tools; Test, Measurement, and Diagnostic Equipment; and Support
Equipment.
Special Tools, TMDE, and Support Equipment is listed in the applicable
repair parts and special tools list and in Appendix B of this manual.
5-12.3 Repair Parts.
Repair parts are listed and illustrated in the Repair Parts
Tools List, TM 5-6675-317-24P covering organizational maintenance for
this equipment.
5-13. SERVICE UPON RECEIPT.
5-13.1 Checking Unpacked Equipment.
a. Inspect the equipment for damage incurred during shipment. If equipment has
been damaged, report the damage on DD Form 6, Packing Improvement Report.
b. Check the equipment against the packing list to see if the shipment is
complete.
Report all discrepancies in accordance with the instructions of DA Pam
738-750.
c. Check to see whether the equipment has been modified.
5-8
