TM 5-6675-316-14
Table 8-3. DIRECT/GENERAL SUPPORT TROUBLESHOOTING - Cont
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
4. WAX COATING IS TOO THICK OR TOO THIN.
Refer to malfunction 3, steps 1 and 2.
5. WAX WILL NOT HEAT COMPLETELY OR TAKES OVER 30 MIN TO MELT.
Refer to malfunction 3, steps 1 and 2.
6. WAX COATING IS ROUGH AND BUMPY.
WAX FILAMENTS TRAIL FROM EDGE OF SHEET.
Refer to malfunction 3, steps 1 and 2.
7. WAX IS MELTED, BUT AMBER OPERATE PILOT LIGHT WILL NOT COME ON.
Step 1.
Turn MOTOR switch ON.
Check to see if rollers rotate.
(a) If rollers rotate, lamp is bad. Replace lamp (paragraph
8-20.4).
(b) If rollers do not rotate, replace motor thermostat (paragraph
8-20.6).
(c) If malfunction is not corrected, proceed to step 2.
8-44
