TM 5-6675-316-14
Section III OPERATOR MAINTENANCE
7-8. LUBRICATION INSTRUCTIONS.
NOTE
These lubrication instructions are mandatory.
7-8.1 Pillow Block Fittings.
Apply ball and roller bearing grease (Item 12,
Appendix E) to both pillow blocks annually.
a.
Apply grease sparingly using grease gun.
b. Wipe grease fittings clean after application.
7-9. TROUBLESHOOTING PROCEDURES.
a.
The table lists the common malfunctions which you may find during operation
or maintenance of the drafting, scribing/tracing table, or its components. You
should perform the test/inspections and corrective actions in the order listed.
b. This manual cannot list all malfunctions that may occur, nor all test or
inspections and corrective actions.
If a malfunction is not listed or is not
corrected by listed corrective actions, notify your supervisor.
7-12
