TM 5-6675-316-14
j .
k.
l.
m.
n.
o.
P.
q.
r.
s .
t .
u.
v.
w.
x.
Remove
Remove
capscrews to release front plate from end plates.
screws and washers securing front plate.
Move defective grid until wires are accessible inside light box.
Disconnect green wire.
Loosen capscrews and washers and remove middle roller as an assembly
from view stage.
Attach to new grid assembly.
Splice red wires from new grid assembly to exposed red wire from
defective assembly.
Thread new wires to transformer terminal.
Desolder old wires from terminal and remove from splice. Solder new
wires to transfer terminal. Attach green wire to ground.
Ground ON/OFF switch to table chassis. Plug in power cord. Turn main
power switch ON.
Turn ON/OFF switch to ON.
Check that grid assembly lights. Turn main
power switch to OFF. Unplug power cord.
Reinstall front plate and secure with screws and washers.
Reinstall ON/OFF switch assembly. Secure with screws.
Aline stage separation knob and view stage. Secure with screw.
Reinstall stage separation plate and secure with screws.
Reinstall end plates and brackets.
Secure to left view stage with
screws.
Secure to right view stage with screws.
Reinstall center accumulator roller.
Raise bottom plate, and secure with knobs.
4-76
