TM 5-6675-316-14
(f)
and lifting from
Remove center accumulator roller by pinching spring-loaded latches
between view stages.
(g) Move stage separation knob to right. Make sure that view stages
close and knob locks into slot.
(h) Thread film leader over rollers across view stage to take-up reel.
(i) Adjust drag brake
suitable for operators use.
knobs on crank handles until film tension is
NOTE
Perform steps (j) through (n) to view dual film strips.
(j) Mount rear film SUPPlY reel on idler bracket. Reel key slot engages
bearing on idler bracket.
key slot.
(k) Slide rear driver bracket to front until drive spindle engages reel
(l) Tighten black knurled locking knob on driving bracket.
(m) Install take-up bracket at opposite end of split-stage light table.
(n) Thread rear film strand.
4-28