TM 5-6675-316-14
ak.
Remove socket head capscrews from rubber stop at front end of Y-rail.
al.
Remove stop.
am.
Move Y-carriage motor locking lever to right.
an.
Slide motor mount to right.
CAUTION
When moving Y-carriage, do not attempt to force movement or damage to gears
and rack may result.
ao.
Move Y-carriage to rear end of Y-rail.
ap.
Remove two socket head capscrews from Y-carriage tensioning device.
aq.
Remove device.
ar.
Remove socket head capscrews from end plate at front end of Y-rail.
as.
Remove plate.
CAUTION
Two personnel are required to remove Y-carriage. One person at Y-carriage
and one person at end of X-rail to remove assembly in level position or
damage to carriage bearings will occur.
at.
Remove Y-carriage with attached X-rail and cables.
au.
Install tensioning device.
av.
Install rubber stop.
aw.
Install end cover.
CAUTION
Glass top is fragile and can be easily broken. Handle with care and do not
allow glass to hit machine frame.
NOTE
Three personnel are required to perform steps bc, bd and be. One person
under table and one at each end of glass.
ax.
Rotate front mounting screws half left.
3-191
