TM 5-6675-316-14
3-20.22 Remove/Install Drafting and Measuring Machine.
MOS: 35E, Special Electronic Devices Repairer
81C, Cartographer
PERSONNEL: Four persons are required to perform this procedure
TOOLS: Flat Tip Screwdriver
Cross Tip Screwdriver
2 mm Hex Head Key Wrench
2.5 mm Hex Head Key Wrench
3 mm Hex Head Key Wrench
1/2 in. Combination Wrench
Accessory Tool Kit (contains
glass)
two special tools for removing
SUPPLIES: Drafting and Measuring Machine
WARNING
Death or serious injury may occur from electrical shock unless power cord
is unplugged before servicing.
a.
b.
c.
d.
e.
f.
9.
h.
i.
J.
k.
l.
m.
3-188
Remove drafting table, teletypewriter, and DSP machine controller power
cords from electrical outlets.
Remove toolholder from dovetail mount on X-carriage.
Loosen retaining screws on four ribbon cable connectors located on left
side of table frame.
Note position and remove cables.
Remove socket head capscrew holding ground wire and cables to center
left side of table frame.
Remove wires and cables from screw.
Reinstall screw in table frame.
Loosen X-rail fine adjustment device setscrew.
Raise arrest stop pin.
Slide device away from arrest.
Remove device.
Remove two socket head capscrews from X-carriage tensioning device.
Remove device.
