TM 5-6675-316-14
Action
Result
Move to point P5. Press Y.
Move to point P6. Press A.
Move to point P7. Press B.
Move to point P8. Press Y.
Move to point P0. Press Y.
Move to point P9. Press A, -, P, 6,
2, 5, and B.
Move to point P10. Press A, -, P, 7,
5, and B.
Move to point PO again. Press X, 7,
and -.
Third line is recorded. Coordinate of
Y in XY Display should not change.
Reference point is stored.
Endpoint and computed arc are
recorded as command.
Fourth line is recorded. Coordinate
of X should not change.
Fifth line is recorded. Coordinate of
Y should not change.
Center point of circle is recorded.
Diameter (0.625 in.) is entered
manually.
Center point of second circle is
recorded. Diameter (0,75 in.) is
entered manually.
Machine is commanded to move
back to starting point. Then EOF
code (7, -) is recorded.
(16) Shift teletype to LOCAL.
(17) Press HERE IS key.
(18) If digitizing is complete, remove digitizing tool.
m. Writing tape drafting program. To write tape program, use commands listed in table 3-7. These
commands tell machine where and how to move. Pen commands determine if command results in line being
drawn or scribed. (A line, circle, or arc will be drawn or scribed if pen or scribing poirt is down when machine
moves, line, circle, or arc will be drawn or scribed.) Commands are written in program lines with no line longer
than 64 characters. Drafting (movement) command code is always first item in program line, followed by pen
commands and/or appropriate coordinate data. All coordinate data is entered with prefixes that identify it as
normal point coordinates X and Y for line or coordinates I and J for center point of circle.
3-102
Change 1
