TM 5-6675-316-14
s.
Wrap carriage cable around motor pulley, to the right, 2-1/4 turns.
t.
Thread carriage cable from the bottom, through groove of right pulley,
around pulley to idler pulley lower groove, then to wayrod support
casting.
u.
Secure second carriage cable with flat washer and two locking nuts.
v.
Reinstall rear panel.
w. Move composing machine back to wall (paragraph 2-16.10).
Reinstall top right cover and reconnect spring.
x.
Reinstall cassette mounting bracket.
y.
z.
Turn on circuit breaker.
Turn on power switch.
aa.
ab.
Reinstall center panel.
ac.
Close top left panel.
Perform diagnostic test.
ad.
2-252
