TM5-6675-316-14
WARNING
This procedure requires four persons. The composing machine weighs 485
pounds. Serious personnel injury may occur unless an adequate number of
persons are used to move equipment.
g.
h. Remove rear panel.
i.
Hold rear locking nut with thin 3/8 in. ignition wrench, while
When front locking nut is loose, place screwdriver in slot on cable end
connector and continue loosening front locking nut until free of
connector.
k. Repeat step j. above, and remove rear locking nut.
l.
Remove flat washer and compression baffle.
NOTE
Tension is now relieved from the carriage cables, and both cables are free
to be threaded from machine.
m.
Remove defective carriage cables.
2-250