TM 5-6675-316-14
NOTE
The following is both the installation procedure and alinement procedure
for the carriage cables.
n.
Insert bead end of first new carriage cable into rear slot of motor
pulley.
Wrap carriage cable left around motor pulley 6-1/2 turns.
o.
Thread carriage cable from the bottom, through groove of left pulley,
p.
-
around the pulley to idler pulley upper groove,then to the wayrod
support casting.
Secure first carriage cable with compression baffle, flat washer and
q.
two locking nuts.
Thread beaded end of second carriage cable into front slot of motor
r.
pulley.
2-251