TM 5-6675-315-14
NOTE
Cutter and comber assemblies are removed in the following sequence:
bushing, ring, special spacer ring, combers, cutters, and cutter ring.
m.
Remove cutter and comber assemblies.
n.
Inspect all components for wear or damage. Replace combers and cutters as required.
NOTE
If blades become dull, new cutting edges may be obtained by simply reversing cutter assemblies
on upper and lower shafts.
NOTE
Cutter and comber assemblies are reinstalled in the following sequence: cutter ring, cutters,
combers, special spacer rings, ring, and bushing.
o.
Reinstall cutter and comber assemblies.
p.
Reinstall special spacer ring, ring, and bushing.
q.
Reinstall top plate and stud bolts, and secure with hex head screws.
r.
Reinstall funnel screws.
2-239
