TM 5-6675-315-14
2-39.3 Repair Conveyor Belt Assembly.
MOS: 83FJ6, Reproduction Equipment Repairer
PERSONNEL: Two persons are required to perform this procedure
TOOLS: Flat Tip Screwdriver
2.3 mm Hex Head Key Wrench
4 mm Hex Head Key Wrench
5 mm Hex Head Key Wrench
8 mm Hex Head Key Wrench
24 mm Combination Wrench
SUPPLIES: Conveyor Belt with Rollers
WARNING
Serious injury to personnel may occur if equipment is energized while removing conveyor belt
drive gear.
NOTE
Shredder-bagger must be moved away from wall for this procedure (paragraph 2-35.11).
a.
Turn circuit breaker OFF.
b.
Turn main power switch off.
NOTE
Screws for bottom side panels are mounted through spacer bushings placed between panel and
frame of shredder-bagger. Do not lose these bushings. They must be reinstalled for panel to be
remounted.
c.
Remove screws and all upper and lower covers.
d.
Remove screws and both right and left conveyor side cover plates.
2-234
