TM 5-6675-315-14
2-39.4 Repair Cutter Assembly.
MOS: 83FJ6, Reproduction Equipment Repairer
PERSONNEL: Three persons are required to perform this procedure
TOOLS: Flat Tip Screwdriver
Gear Puller
6 mm Hex Head Key Wrench
10 mm Combination Wrench
24 mm Combination Wrench
8 mm Socket, 3/8 in. Drive
3/8 in. Drive Ratchet
Ball Peen Hammer
SUPPLIES: Combers
Cutters
Small Block of Wood
GAA Grease (Item 6, Appendix E)
WARNING
Serious injury to personnel may occur if equipment is energized while removing cutter unit
assembly.
a.
Turn off circuit breaker.
b.
Turn off main power switch.
c.
Remove screws, automatic oil covers, and right and left upper covers.
NOTE
Screws for bottom side panels and U-cover are mounted through spacer bushings placed
between panel and frame of shredder-bagger. Do not lose these bushings. They must be
reinstalled for panel to be remounted.
d.
Remove rear U-cover.
e.
Remove paddle assembly (paragraph 2-35.10).
f.
Loosen clamp and remove centrifugal switch from motor.
g.
Tag and disconnect motor wiring. Then remove gasket and cover.
h.
Remove four mounting bolts and washers and cutter assembly from machine.
2-237