TM 5-6675-315-14
NOTE
Amount of tension applied must be identical on both sides of belt or belt will try to ride off
chassis. Normal range is 4.92-5.31 in. (12.5 - 13.5 cm).
f.
Measure tensioning distance from bottom of chassis rail to bottom of belt below on each side.
g.
Adjust tension evenly on both sides by turning tensioning screws until belt no longer has tendency to ride off
chassis.
h.
Check that tensioning distance on both sides of belt is identical.
i.
Lock tensioning nuts in place.
j.
Reinstall cutter side panels.
k.
Turn on circuit breaker.
l.
Turn on main power switch.
2-89