TM 5-3610-287-24
2-48. REPAIR POWER ENTRY PANEL ASSEMBLY (CONT)
NOTE
An extra person outside Section is required for the
following procedure.
3.
Inside Section at dc power receptacle (3), remove hex nuts (4) and
lockwashers.
Outside Section, pull back dc power receptacle (3). Remove screws
4.
(5) and dust cover (6) from dc power receptacle (3).
5.
Tag and desolder wires (7) according to pins (8) inside dc power
receptacle (3).
6.
Solder wires (7) to pins (8) inside new dc power receptacle (3).
7.
Install new dc power receptacle (3) and dust cover (6) with
screws (5).
8.
Inside Section at new dc power receptacle (3), install lockwashers and
hex nuts (4).
Install power entry panel cover (2) with screws (l), lockwashers, and
9.
flatwashers.
10.
To test operate, connect external 12-volt dc power source and
ensure dome lights are operational.
If necessary, paint dc power receptacle in accordance with
11.
TM 43-0139.
DUPLEX RECEPTACLE
INITIAL SETUP
Tools
Light machine repair tool kit (appendix B, section III, item 11)
Cross-tip screwdriver
Flat-tip screwdriver
Extension light
Combination wrench set
Scraping knife (appendix B, section III, item 9)
2-142
