TM 5-3610-287-24
REPAIR
POWER ENTRY PANEL ASSEMBLY (CONT)
2-48.
WARNING
Cables and wires on new main power receptacle MUST be tagged
and installed in exactly the same order as on old
receptacle. Failure to observe this warning may result in
death or serious injury.
4.
Tag power input cables (3) and power monitor assembly wires (4).
Loosen terminal block screws (5) and remove cables (3) and wires (4).
5.
Pull loose power input cables (3) down through conduit (6).
6.
7.
Remove hex nut (7) and starwasher from grounding terminal (8). Remove
ground cable (9).
NOTE
An extra person outside Section is required for the
following procedure.
Inside Section, remove hex nuts (10), lockwashers, and flatwashers
8.
from power input receptacle (11).
Outside Section, pull power input receptacle (11) and power input
9.
cables (3) from power entry panel (12). Remove hex bolts (13).
WARNING
Cables and wires on new main power receptacle MUST be
tagged and installed in exactly the same order as on old
receptacle. Failure to observe this warning may result in
death or serious injury.
Outside Section, feed cables (3) through power entry panel (12).
10.
Position new main power receptacle (11) so that dust flap opens from
bottom and lifts up.
11.
Outside Section, install hex bolts (13) in power input
receptacle (11).
Inside Section, install flatwashers, lockwashers, and nuts (10) on hex
12.
bolts (13).
Install ground cables (9), starwasher, and hex nut (7) on grounding
13.
terminal (8).
14.
Insert power input cables (3) through conduit (6).
2-139
