TM 5-3610-287-24
2-34.
REPAIR MODIFIED FIVE-DRAWER STORAGE CABINET (CONT)
1.
If necessary, remove thumbscrew and securing bar from front of
cabinet (1).
2.
Open drawer (2) and remove plate (3) by pulling at center hole inside
drawer (2).
Remove cotter pin (4) and spring (5).
3.
Remove latch bar (6) and knob (7).
4.
Install new latch bar (6) and knob (7). Secure with spring (5) and
5.
cotter pin (4).
6.
Remove screw (8) securing handle (9) to drawer (2).
7.
Install new handle (9) with screws (8).
8.
Install plate (3) inside front of drawer (2).
Close drawer.
9.
If necessary, install securing bar over front of cabinet (1) and secure
with thumbscrew.
2-35. REPLACE JOGGING TABLE ASSEMBLY AND FEEDER PILE BOARD STORAGE RACK
This task covers: a.
Removal b.
Installation
INITIAL SETUP
Tools
Light machine repair tool kit (appendix B, section III, item 11)
Socket wrench set
Flat-tip screwdriver
Cross-tip screwdriver
Materials/Parts
Jogging table assembly, 13227E5706
Feeder board locking bracket, 13226E7926
Feeder storage rack support frame, 13226E7893
Wood feeder guide, 13226E7886 (2 required)
Steel feeder guide, 13226E7885
Feeder board locking brace, 13226E7898
2-86
