TM 5-3610-287-24
2-35. REPLACE JOGGING TABLE ASSEMBLY AND FEEDER PILE BOARD STORAGE RACK
(CONT)
Remove drawer (11) and open cabinet doors (12). Remove hex bolts
7.
(13), lockwashers, flatwashers, and stiffener bar (14) inside cabinet.
8.
Remove screw (15) from support bracket (16).
WARNING
Jogging table assembly weighs approximately 200 pounds (91
kg) . Use proper lifting techniques. Do not attempt to lift
by yourself. Failure to observe this warning may result in
personal injury.
Pull jogging table assembly away from wall.
9.
10.
Remove screws (17), bolts (18), lockwashers, and flatwashers. Separate
feeder storage rack support (19) from jogging table assembly.
Remove screws (20), lockwashers, and flatwashers. Separate locking
11.
bracket (21) from wall.
12.
Remove screws (22) securing each feeder guide (23) to floor. Remove
feeder guides (23).
INSTALLATION
1.
Install each feeder guide (23) with screws (22).
2. Install locking bracket (21) with screws (20), lockwashers, and
flatwashers.
3. Install feeder storage rack support (19) on jogging table assembly
with bolts (18), flatwashers, and lockwashers. Install screws (17).
WARNING
Jogging table assembly weighs approximately 200 pounds (91
kg). Use proper lifting techniques. Do not attempt to lift
by yourself. Failure to observe this warning may result in
personal injury.
Position jogging table assembly against wall.
4.
Install feeder bar rack support bracket (16) with screw (15).
5.
2-88
