TM 5-3610-286-20
2-84.
Universal Joint Shaft (cont).
d. Install. (figure 2-235)
(1) Install needle bearing (1) In feeder frame.
(2) Install washer (3) and install D/S of shaft (3) in feeder frame.
(3) Install washer (4), sprocket (5), and spring pin (6).
(4) Aline timing notches (7) on shaft flange (8) and suction assembly flange (9).
(5) Install two Iockwashers (10), washers (11), and hex screw (12).
(6) Install link section (13) in chain end (14), and install C-clip (15).
e. Aline. Alinement of universal joint shaft is covered in suction head alinement (para. 2-85).
NOTE
FOLLOW-ON MAINTENANCE:
Adjust chain tension.
2-472
