TM 5-3610-286-20
2-84.
Universal Joint Shaft (cont).
b. Inspect.
(1) Check siphons for tears, cracks, and dryrot.
(2) Check universal joints for binding and free movement.
(3) Check shaft for cracks, bends, or worn bushings.
(4) Check sprocket for burred, cracked, or missing teeth.
c. Repair. (figure 2-234)
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
(11)
(12)
(13)
(14)
(15)
2-470
Remove four hex screws (1), hex nuts (2), and clamping rings (3).
Remove siphons (4) and (5).
Remove spring pin (6) and bearing bolt (7).
Remove spring pins (8), shaft section (9), covering sleeve (10), and bushings (11).
Separate shaft sections (12) and covering sleeve (13).
Remove spring pins (14), and separate universal joint (15) from shaft section (12) and
flange (16).
Replace unserviceable items identified in the inspect procedure.
Replace and aline flange (16) and shaft section (12) in universal joint (15). Replace
spring pins (14).
Slide siphon (5) over universal joint (14).
Slide covering sleeve (13) on shaft section (12).
Replace bushings (11) in covering sleeve (10).
Replace covering sleeve (10) on shaft section (12).
Replace shaft section (9) and spring pins (8).
Replace bearing bolt (7) in universal joint on shaft (9), and replace spring pins (6).
Replace siphon (4), clamp rings (3), hex nuts (2), and hex screws (1).
