TM 5-3610-286-20
2-84.
Universal Joint Shaft.
This task covers:
a. Remove
b. Inspect
c. Repair
d. Install
e. Aline
INITIAL SETUP
Tools
Equipment Conditions
0.050 x 0.375 x 8 in. flat-tip screwdriver
Chain tension relieved
10 mm combination wrench
8 mm pin punch
Ball-peen hammer
a. Remove. (figure 2-233)
NOTE
Lock suction head assembly in position before removing universal joint shaft to
preserve timing.
(1) Remove clip (1), link sections (2), and chain (3).
(2) Remove spring pin (4), sprocket (5), and washer (6) from D/S of shaft.
(3) Remove two hex screws (7), washers (8), Iockwashers (9), universal joint shaft (10),
and washer (11).
(4) Remove needle bearing (12) from feeder frame.
2-468
