TM 5-3610-286-20
2-82.
Sheet Smoother and Accessories.
This task covers:
a. Remove
b. Repair
c. Install
INITIAL SETUP
Tools
Tools (cont)
3 mm pin punch
8-inch brass drift
4 mm pin punch
1.0 x 6.0 x 0.5 mm flat-tip screwdriver
5 mm hex key
Ball-peen hammer
10 mm combination wrench
a. Remove. (figure 2-228)
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
2-458
Remove six sheet guides (1).
Remove two socket-head screws (2), washers (3), and safety guard (4).
Remove four screws (5) and two holders (6).
Remove spring pin (7) and collar (8).
Raise sheet smoother (9) to the upright position to relieve spring tension.
Release spring (10), and slide end of sheet smoother (9) towards D/S until pivot head
(11) is clear of shaft (12).
Slide sheet smoother (9) toward O/S until D/S pivot head (13) is clear of shaft (14).
Remove two pins (15) and pivot heads (11, 13).
Remove washer (16), spring (10), and shafts (12) and (14).
