TM 5-3610-286-20
2-81.
Transfer Drum.
This task covers:
a. Remove
b. Inspect
c. Repair
d. Install
INITIAL SETUP
Tools
Equipment Condition
6 mm hex key
Press in “O” set position
8 mm hex key
Delivery guard open (TM 5-3610-286-10)
2 mm pin punch
10 mm combination wrench
0.50 in. flat-tip screwdriver
Ball-peen hammer
a. Remove. (figure 2-226)
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
(11)
(12)
2-454
Push each rod (1) toward spring (2) and remove rods.
Remove spring tension pin (3) and spring (2) from each rod (1).
Remove star wheels (4) and supporting discs (5).
Mark position of quadrants on shaft so that gripper bar will move in gap.
Remove two socket-head screws (6) from each quadrant (7) and separate and remove
three quadrants.
Remove two socket-head screws (8) from each support bracket (9) and remove two
support brackets and square bar (10).
Remove two set screws (11) and slide four strap guides (12) off square bar (10).
Remove spring (13) from each strap guide (12).
Remove two socket-head screws (14) from each bracket (15) and remove two brackets
and bar (16).
Remove two socket-head screws (17) and remove brackets (15) from bar (16).
Remove two socket-head screws (18) and ribbed washers (19) from each chain guide
(20) and remove two chain guides.
Remove four socket-head screws (21) and ribbed washers (22) and remove cam
gripper (23)
