Figure 2-224.
TM 5-3610-286-20
2-80.
V. Belt.
This task covers:
a. Replace
b. Adjust
INITIAL SETUP
Took
Equipment Conditions
19 mm combination wrench
Belt guard removed (para. 2-17)
24 mm combination wrench
Machinist’s rule
a. Replace. (figure 2-224).
(1)
(2)
(3)
(4)
(5)
(6)
Loosen nut (1) and tension adjusting screw (2).
Loosen four motor mounting bolts (3) and slide motor (4) toward flywheel (5).
Remove V-belt (6) from drive pulley (7) and flywheel (5).
Replace V-belt (6) on drive pulley (7) and flywheel (5).
Slide motor (4) away from flywheel (5) and tighten four motor mounting bolts (3).
Adjust belt tension (para b.).
2-452
