TM 5-3610-286-20
2-73.
Deflector Assembly.
This task covers:
a. Remove
b. Repair
c. Install
INITIAL SETUP
Tools
Equipment Conditions
Retaining-ring pliers
Upper guard (O/S) removed (para. 2-18)
4 mm pin punch
Ball-peen hammer
Additional Personnel Requirement
8 mm combination wrench
10 mm combination wrench
Printing and Binding Specialist MOS 83F20
19 mm combination wrench
a. Remove. (figure 2-196)
(1) Remove hex nut (1) and cover plate (2).
(2) Remove spring (3) from control lever (4).
(3) Remove hex nut (5) and spring retainer plate (6) from control lever (4).
(4) Remove pin (7) and move rod (8) away from lever (4).
(5) Remove retaining ring (9), washer (10), and control lever (4) from shaft (11).
(6) Remove retaining ring (12) and washer (13).
(7) Remove spring tension pin (14), snap lever (15) with spring rod assembly (16).
(8) Remove external retaining ring (17), washer (18), roller (19), and spring rod
assembly (16).
(9) Remove hex screw (20) and hex nut (21) from guide piece (22).
2-402