TM 5-3610-286-20
2-26.
Oscillator Lever Assemblies.
This task covers:
a. Remove
b. Repair
c. Install
INITIAL SETUP
Tools
Equipment Conditions
Retaining-ring pliers
Main guard assembly (D/S) removed
10 mm combination wrench
(para. 2-20)
17 mm combination wrench
19 mm combination wrench
30 mm combination wrench
Spanner wrench
5 mm hex key
6 mm hex key
10 mm hex key
4 mm pin punch
5 mm pin punch
Ball-peen hammer
Bushing driver set
a. Remove. (figure 2-41)
(1) Remove two spring pins (1), crown nut (2), and washer (3).
(2) Remove two spanner nuts (4) and two retainer washers (5).
(3) Loosen hex nut (6) and remove oscillator lever (7).
(4) Remove hex nut (8), washer (9), and pull rod (10).
(5) Remove six socket-head screws (11), washers (12), and bushing (13).
(6) Remove retaining ring (14), washer (15), flange (16), and screw (17).
(7) Remove three socket-head screws (18), washer (19), and bearing housing (20).
(8) Remove retaining ring (21) and washer (22).
(9) Remove hex screw (23), washer (24), spring rod guide (25), and spring rod
assembly (26).
2-124
