TM 5-3610-286-20
2-25.
Roller Guide Rail Assemblies.
This task covers:
a. Replace
b. Repair
INITIAL SETUP
Tools
Equipment Conditions
5 mm hex key
Inking rollers no. 7,8,9,10,11,12, and
6 mm hex key
13 removed (TM 5-3610-286-10)
8 mm hex key
a.
b.
2-122
Replace. (figure 2-39)
NOTE
Removal procedure for D/S of press shown. Procedure for O/S side is the
same.
(1) Remove two socket-head screws (1).
(2) Remove roller guide rail (2) through delivery end of press. Rotate as required to clear
dampening rollers.
(3) Replace roller guide rail (2) through delivery end of press and aline hole in roller guide
closest to press side frame with locating stud (3) in press side frame.
(4) Replace two socket-head screws (1).
Repair. (figure 2-40)
(1)
(2)
(3)
(4)
(5)
(6)
Remove socket-head screw (1), latch (2), and set screw (3).
Loosen lock nut (4) and remove knurled locking screw (5) and socket-head screw (6).
Replace missing or stripped screw (5, 6).
Tighten lock nut (4).
Replace missing set screw (3).
Replace bent or damaged latch (2) and replace socket-head screw (1).
